@device(x2700)
@majorheading[TelePAC Fault and Crash History]
@verbatim[
?? Aug 85 TelePAC delivered on loan
?? Oct 85 Version: 1256
?? Oct 85 Crash while configuring it
=================================================================
?? Jan 86 H Harware fault on CPU board
30 Jan 86 Version 0167 (major release)
6 Feb 86 Version 0260 (corrections)
17 Mar 86 Version 0368 (corrections & enhan)
18 Mar 86 07.30 O Ops reloaded in an attempt (failed) to clear line
18 Mar 86 13.00 O Re-boot to enable passwords
18 Mar 86 13.45 S Crashed (no buffs) when erte stopped (92 calls)
19 Mar 86 00.00 O Re-boot to enable Low Buff Limit
28 Mar 86 ************** Delivery of New TelePAC - Version 0464
31 Mar 86 23.55 L O Re-boot to change channel numbers on JANET link(80)
1 Apr 86 13.00 L O Re-boot to change channel numbers on JANET link(64)
-------------------------------------------------------------------------
8 Apr 86 O New Telepac brought into service - version 0466
Problems with a clocked line to lau 07 on the CPSE, it
produced a steady rate of crc errors & the line was
brought down by a BAD ADDRESS on the TelePAC
10 Apr 86 13.00 O Re-boot to change no of channels
23 Apr 86 O SEEL engineer powered-off by accident
-----------------------------------------------------------------------
29 Apr 86 ************** Delivery of full 30 line, 2Mb Telepac - s/w vsn 0468
2 MAY 86 13.00 O REBOOT to change no. of logical channels
14 May 86 13.00 O Put version 0451 into the 2Mb Telepac
15 May 86 13.00 O Reverted to vsn 0468 (256 byte pkt problems)
29 May 86 00.00 {S} Bus Error on TEST Telepac (while running data in test)
30 May 86 11.00 {N} I-Field Error brought down a PAD line (timed by PAD -
5 metre cable) on TEST Telepac - NO OTHER FAULTS Counted
21 Jul 86 08.00 H Hardware fault over weeked, backplane back at 1500 with
4 lines missing
22 Jul 86 13.00 O Backplane replaced
?? Jul 86 13.00 ? Replacement of V24 boards started to fix CRC problems
30 Jul 86 10.30 H Crashed with BUS MASTER on soid, pushed board in & reset
28 Aug 86 13.00 O Version 664 installed in main TelePAC
30 Sep 86 2nd TelePAC delivered
5 Sep 86 10.00 1 H Bus Master, lines 3/4 on solid, pushed board but reoccured
immediately, swapped DIO with 2nd TelePAC.
5 Sep 86 1 N Line 19 again failed to start properly on the power up
11 Sep 86 13.00 1 O DIO board #1 swapped with board #7 on telepac #2
suspected h/w problem as blocks were being concatenated
11 Sep 86 13.00 2 O See above
18 Sep 86 13.00 1 O DIO board #9 (line 18) swapped out
18 Sep 86 13.00 2 O DIO boards 2 & 7 swapped out (2 caused Bus Master problems
on T1 & L2 problems on T2)
]